Use offcuts first - Nesting

 

Nesting parameter to set how offcuts are used

 

mct2004-01.gif

 

Use this value to set whether any offcuts in the board list are used before boards. This affects the optimisation process and forces offcuts to be used up where possible, but it does not affect the board sequence as the nested patterns are sorted according to the parameter ‘Board sequence’ after optimisation.

 

Check the box to allow this.

 

tickbox9.gif Use offcuts first

 

 

Notes

 

- Can also be set as a Material parameter at material level.

 

- Applies to Shaped Nesting II and Rectangular Nesting

 

- This parameter is not available if 'Consider offcuts' is not checked

 

 

See also