System parameter to set how runs are named
When an optimised run is produced the name for the run can be based on the part list/cutting list name or on a sequential run number. The options are:-
Use cutting list for name of optimised run
Use sequential number for name of optimised run
- Select the option via the radio buttons
For example:-
Part list name: EXAMPLE32 > Run name: EXAMPLE32
Part list name: EXAMPLE32 > Run name: 10145
Notes
- The following saw transfer modes cannot use the part list name.
3 CADmatic 1
4,5 CADmatic 2
7 Homag Sawtech
10 SCM
The program assigns numbers on transfer to the saw - using these transfer modes.
|