Optimising parameter to set how optimisers operate
For cutting lists with larger quantities there can often be a reasonable tolerance on the overs or unders produced. In these cases it can be useful to allow up to a full sheet of overproduction. To work in this way check the box to allow full sheet overs.
Allow
full sheet overs
For this option the Optimising parameter: Optimiser type must be set to an approriate optimiser type.
Notes
- Can also be set as a Material parameter at material level.
- The over production constraints set at the part list may be exceeded by up to 1/2 a sheet of a part. For example, if 10% overs are set, some parts may still produce up to half a sheet more than this.
- This method is NOT suitable for lists which contain relatively small parts.
If number in half sheet is greater than the number of overs allowed for the part, the part is too small for this method.
![]() |