Information box to store a file name for transfer of data to a machining centre
There are three types of instructions for machining.
- Instructions for the front of the piece
- Instructions for the back of the piece
- Instructions for horizontal operations on the piece (e.g. drilling)
These can be sent to a single file or split into separate files. Where the Machining centre transfer parameter:Use common transfer name for parts is checked this information box must also be set. The program uses this box to store the common name.
For more details see the topic: Set up for transfer of Machining instructions
Set this parameter via. Parameters - Information boxes. The parameter is in the 'Machining drawings' section.
