Machining centre transfer parameter to control transfer of runs
Only applies to transfer type: 8 - Homag Woodwop V4->V8 (MPR/X) and only for Machining library drawings.
This is useful if the origin used in the Machining library is different to the origin in 'WoodWOP'.
Use this value to set the origin for the drawing files for transfer. The options are:-
Bottom left
Top left
Top right
Bottom right
Use the list box to select a value
The value must be compatible with the Machining centre parameter: Drawing origin. That is, the value must be the same as the 'Drawing origin' or rotated by 180 degrees. For example, If the 'Drawing origin' is set to Top Left; Part machine origin is either Top Left or Bottom Right