Pre-stacking table

 

Saw parameter - to set whether a pre-stacking table is included

 

prestasckingtable.gif

 

Some rear loading single saws have a separate pre-stacking table which can operate concurrently with other saw operations.

 

tickbox9.gif Check the box to set this parameter

 

Typically, without a pre-stacking table of this type, the loading for the next cycle (on to the rear of the saw) cannot start until the current cycle is complete; with the pre-stacking table the extra table can be loaded whilst the previous cycle is being cut. Cutting time over several cycles can be reduced by this configuration..

 

 

Notes

 

- This parameter only applies to 'Rear loading' saws.

 

- Single saw simulation diagrams show a separate line for the pre-stacking operation.

 

- Can also be set as a material parameter at both board and material level

 

 

See also