Set contour start rout

 

Machining centre parameter to set DXF import options

 

mch08-16.gif

 

When working with DXF based parts this parameter is used to set how a contour is interpreted when the DXF part drawing is imported.

 

The options are:- 

Leave unchanged

Longest

Longest in X

Longest in Y

 

Leave unchanged - means leave the contour start as defined by the polyline in the DXF file.

Longest - means start halfway along the longest groove rout in the contour.

Longest in X - means start halfway along the longest horizontal groove rout in the contour.

Longest in Y - means start halfway along the longest vertical groove rout in the contour.

 

This is useful if the DXF drawing has been set up to start from one of the corners of the contour - this setting adjusts the start to a more practical point for machining.

 

Notes

- For the last two types, if there are no horizontal (or vertical) groove routs in a contour then the start will be unchanged.

 - If a contour is only comprised of arcs no change is made to the start.

 

 

See also