Saw parameter to allow more time for each combiTec cut
When using the combiTec recut method (where recuts are taken as part of the rip cycle) the saw requires extra time to take the recuts to allow for the saw blade slowing down at the start and end of each recut.
The combiTec recuts are shown in red below.
- Enter a value in seconds.
Where the saw parameter (Speeds and Times 1): Faster operation with small books is set also enter a time from the small book operation.
This time is typically in the range 2 - 4 seconds.
The allowed range is: 0.0s - 99.9s and the default is 0.0s.
| See help topic: combiTec |
|