Routing / Nesting system parameter to set whether MPR(X) part borders are overriden for nested patterns
When any of the following options are selected, then any borders on the MPR(X) parts need to be overridden so that the order of the various passes is correct:
Stay down (with or without tabs)
Common edging (with or without tabs)
Piece by piece with tabs
Preliminary pass routing
Small parts pass routing
If the system parameter located on the routing/nesting page - 'Override MPR(X) part borders for patterns' is checked, then MPR(X) part borders are disabled on the resulting nested patterns generated by project manager.
Override MPR(X) part borders for patterns
Note
- This parameter only operates when a version of WoodWOP with documentplugin is installed.