Parts produced in excess of or below requirements
These fields are used throughout the program where parts are viewed or edited. They specify the amount of over production or under production allowed for a part when optimising.
- Enter a value if required
Notes
- For optimising the program automatically balances the use of over or under production and only allows overs or unders where there is a significant cost saving.
- To NOT allow under or over production enter a value of 0 or leave the field blank
- At the part list the global line can be used to enter a percentage that applies to every item in the list. Set the value in the global line to '99' to allow the program to automatically calculate the number of overs equal to a full sheet (use this for large volume runs only). If a value is set in the global line the value is a percentage but on each individual part line the value is the number of overs or unders allowed.
