Transfer mode and Saw model conflict

 

Which transfer modes match with which saw controller

 

Not all transfer modes are supported (or needed) for some saw model types. This is a list of the saw models and the transfer modes they support.

 

Saw model                               Transfer mode supported

4 -  Compumatic                           1 2 3 4 5 6 8 11 12

7 -  Compumatic I (ANGULAR)               0 1 2 3 4 5 6 8 11 12

8 -  Digimatic                            1 2 3 4 5 6 8 11 12

9 -  Compumatic II, Topmatic, Micromatic  0 1 2 3 4 5 6 8 11 12

21 - CADmatic (9)                         2 3 4 5 6 8 11 12

22 - CADmatic                             2 3 4 5 6 8 11 12

23 - CADmatic (14)                        2 3 4 5 6 8 11 12

24 - CADmatic-offset head saw (15)        2 3 4 5 6 8 11 12

25 - CADmatic-turntable at rip saw (16)   2 3 4 5 6 8 11 12

31 - CH06, CH10 (Homag)                   2 7 8 11 12

32 - CH12                                 2 7 8 11 12

33 - CH12 (CNI controller)                2 7 8 11 12

34 - CH12 (NPS400 V3)                     2 7 8 11 12

35 - Cannon 2020                          0 2 8 11 12

41 - Sliding Table Saw                    Does not apply

51 - Schelling                            2 8 9 11 12 13

61 - SCM                                  2 8 10 11 12

71 - Cut instructions - machining centre  Does not apply

81 - ASCII CPOUT                          2 8 11 12 14

 

The relevant parameters are:-

 

Saw transfer parameter: Transfer mode

Saw parameter: Saw model number

 

 

See also