Transfer to module programmer

 

How to use the module programmer

 

Press the 'READ' button on the programmer

 

The lights should now indicate 'ready to read'

 

Use the optimising program to enter the information required for transfer (e.g. Group to transfer, group reference, module file number), and press [Rtn] or [End] to start the transfer.

 

Initially you will see the Standby light go out leaving just the Read light on.

 

After 15-30 seconds the 'Transfer OK' light on the programmer unit comes on indicating a successful transfer.

 

If this does not happen you see an error light on the programmer. Check the connections and procedures and try again.

 

The dimensions are now held in the programmer unit and must next be stored in the module. Insert a module in the socket at the front of the programmer unit.

 

Press the 'SAVE' button on the programmer. The programmer transfers the data into the module. On completion of the process the 'Transfer OK' light comes on, or the error light if unsuccessful. The portable module is now loaded and ready to be plugged into the saw controller.

 
 
See also