Saw model

 

Saw parameter to set type of saw in use

 

 

Set this parameter before any others as the Saw model determines which other saw parameters are available. This is the first parameter on the 'Cutting 1' tab.

 

Select the appropriate saw model from the list

 

Single saws

 

1 - Homag/Holzma STG 16 (Videomatic)

2 - Homag/Holzma STG 19 (Videomatic)

3 - Homag/Holzma STG 16/19 + graphics (Videomatic)

4 - Homag/Holzma Compumatic I

8 - Homag/Holzma Digimatic

9 - Homag/Holzma Compumatic II / Topmatic / Micromatic

21 - Homag/Holzma CADmatic 1/2/3/4/5 / Giben-Optilink / Selco-CRLINK

26 - HOMAG flexTec CADmatic 5

 

Angular saws

 

5 - Homag/Holzma STG 13 (Videomatic)

7 - Homag/Holzma Compumatic I

11 - Homag/Holzma Compumatic II

22 - Homag/Holzma CADmatic 1/2/3/4/5

25 - Homag/Holzma CADmatic 1/2/3/4/5 (with turntable at rip saw)

 

Three saw systems

 

12 - Homag/Holzma Compumatic II

23 - Homag/Holzma CADmatic 1/2/3/4/5

24 - Homag/Holzma CADmatic 1/2/3/4/5 (with offset head saw)

 

Other saw types

 

31 - Single Homag CH06/CH10/CH12 and NC-16 controller

32 - Single Homag CH06 saw and NC-16 controller

33 - Single Homag CH04/CH10/CH12/CH03+ saw and NPS400v2xxx/IPC/VIC800S CNI controls

34 - Single Homag CHF320/CHF41/CHF51/CH03+ with PC controller (NPS400 V3xxx/Ilenia)

35 - Single Homag CHF320/CHF41/CHF51/CH03+ with PC controller (NPS400 V3xxx/Ilenia)

41 - Sliding table saws

51 - Single Schelling

61 - Single SCM

62 - SCM Seziona

71 - Machining centre

81 - Single saw - CPOUT compatible

91 - Homag/Weeke Cutting Centre

 

 

Notes

 

- Take care when changing the Saw Model because when the Saw model is changed this clears any parameter values that are not applicable to the new saw model type - check the new parameters carefully.

 

 

See also