Saw transfer parameter to control whether data is buffered or not
The parameter is shown on the right hand pane at the saw transfer parameter screen and is only required for some saw modes. Select the correct saw mode(s) before attempting to set this parameter.
Data for transfer to most saw controllers is stored in a directory on the PC in the location set by the Path parameter. On choosing Transfer to saw the contents of this directory are sent to the saw and the directory contents are automatically deleted. Where there are several users on a Network who send data to the saw directory a Supervisor may want to review the data in the saw directory before it is dispatched to the saw. To work in this way select: Buffered transfer
The saw buffer can be managed using the Buffered transfer to saw options.
Check / uncheck the box to set the parameter
Buffered
transfer
