Source for laminates

 

System parameter to set where laminates are located

 

 

Typically edging materials are stored in the edging library and when edging is used in the part list / cutting list the program looks at the edging library to locate the edging material and make the edging adjustments for the cutting list.

 

The edging library can be inconvenient to use if there is a lot of sheet laminate material rather than tape or pre-cut strips. In this case it is often easier, especially with a wide variety of laminate colours, to use laminates from the Board library or the Board list.

 

Use this parameter to set the method of operation. The options are:-

 

Edging library

Board library

Board list

 

Select the option via the radio buttons

 

 

See also