Maximum number of patterns in a run that can be transferred to the saw
The transfer process splits runs on the basis of this setting.
The type of saw controller (chosen by Saw parameter: Saw model) may set an overall limit to the number of patterns per run but this parameter may also be used to limit the value further as some saw models cover several similar controllers, for example, Saw model number 33 covers several related saw controllers.
When splitting runs the program uses the lowest value comparing this setting with the default value determined by the saw model. A value of 0 or 9999 means this parameter is ignored.
Note - If the number of patterns per run is quite low this may produce a large number of extra runs so the run number may be 6, 7 or 8 digits. Some saws do not deal with run numbers greater than 6 digits - in this case reduce the size of the original run.
For example - Original run number: 10023 - 600 patterns. With a limit of 20 patterns per run you need 30 new runs.
0110023
0210023
.....
3010023
|